Hey there! We just put together a couple videos that demonstrate looping with our TimeLine delay.

TimeLine Looper Basics

In this first video, we go over the basic looping features available from the front panel. All you need to do is press and hold TAP to enter looper mode, and you can access Record, Overdub, Play, and Stop. All of your delay knobs and parameters are accessible while looping. You can also set the looper to be pre-delay or post-delay. Running the looper pre-delay allows you to record your dry signal and affect the recorded signal with the delay sounds. Routing the looper post-delay will record the delay sounds to the loop. Check it out:

TimeLine Looper MIDI Control

If you want to take your looping a bit further, you can do so by connecting a MIDI controller to your TimeLine. Here we’re using a Voodoo Lab Ground Control Pro, though any MIDI foot controller that can utilize MIDI CC or note messages should work fine. Connecting a MIDI controller will give you access to additional looping features: Reverse, Half Speed, Undo to Initial Loop, Redo, and Looper Pre/Post. In this video, we showcase of these additional features and advanced looping techniques.

Setting up your MIDI controller

You can set up your MIDI controller with either MIDI CC (continuous controller), or MIDI note numbers.

MIDI CC values:

Record – CC# 87, any value
Play – CC# 86, any value
Stop – CC# 85, any value
Reverse (toggle) – CC# 94, any value
Full/Half Speed (toggle) – CC# 95, any value
Pre/Post (toggle) – CC# 96, any value
Undo (to initial loop) – CC# 89, any value
Redo – CC# 90, any value
Looper Level – CC# 98, value range 0-17

Note values:

Record – note 0, velocity > 0
Play – note 2, velocity > 0
Stop – note 4, velocity > 0
Reverse (toggle) – note 14, velocity > 0
Full/Half Speed (toggle) – note 16, velocity > 0
Pre/Post (toggle) – note 17, velocity > 0
Undo (to initial loop) – note 7, velocity > 0
Redo – note 9, velocity > 0