How do I set MiniSwitch to be used as a tap tempo switch?

MiniSwitch can be used as a tap tempo switch with BigSky, DIG, DecoFlint, Mobius, and TimeLine.  To set up your MiniSwitch for Tap Tempo mode, follow these steps:

  1. Unscrew the four screws on the bottom of the chassis.
  2. Once opened, locate the small jumper underneath the circuit board and switch it from the center and right pins to the center and left pins. Please see the image below.

MiniSwitch modes
Once you have the MiniSwitch configured to Tap Tempo Mode you still need to make sure your Strymon pedal is set up to recognize an external tap tempo pedal.

Flint/DIG

Power up while making sure that both conditions below apply:

  1. Both toggle switches are in the DOWN position
  2. You are pressing both footswitches simultaneously.
  3. Release the footswitches after 5 seconds to use the pedal.

Deco

  1. Power up holding BOTH footswitches.
  2. While holding down both footswitches, turn the SATURATION knob to the 12 o’clock noon position to use MiniSwitch as a Tap Tempo switch to control the LAG TIME of the Doubletracker.
  3. Release the footswitches to use the pedal.

TimeLine/BigSky/Mobius

  1. Press and hold the Value knob for 2 seconds to access the Globals menu.
  2. Scroll through the menu options until you see EXP MD (this stands for “Expression Mode”).
  3. Once there, press down on the VALUE knob.
  4. Turn the VALUE knob to set the mode for TAP.
  5. Press the TYPE knob to exit the Global menu.