Mono and Stereo Connections

Each of our Strymon digital effect pedals (excludes OB.1) have the ability to be used with mono or stereo connections.  Here are 3 different connection setups you can use with these pedals. Mono Input => Mono Output For Compadre, Riverside, and Sunset:  Connect a standard mono TS instrument cable into the INPUT and connect a mono TS instrument cable to the OUTPUT of the pedal. For blueSky and Ola:  Connect a mono TS instrument cable into the LEFT INPUT and LEFT OUTPUT for a mono connection. For BigSky, Mobius, NightSky, TimeLine, and Volante:  Connect a mono TS instrument cable into the LEFT INPUT and LEFT OUTPUT for a mono connection.  On the TimeLine and Mobius ONLY, make sure that the switch on the back of the pedal is set to STEREO IN/OUT. For all other Strymon two footswitch Strymon pedals, connect a standard mono TS instrument cable into the INPUT and connect a mono TS instrument cable to the LEFT OUTPUT of the pedal. Mono Input => Stereo Output For Mono INPUT and Stereo OUTPUT on our small 2 footswitch pedals:  Connect a standard mono TS instrument cable into the INPUT and connect a mono TS instrument cable to both the LEFT and RIGHT OUTPUTS of the pedal.  (excludes Compadre, Riverside, and Sunset) For blueSky and Ola:  Connect a mono TS instrument cable into the LEFT INPUT and a mono TS instrument cable to both the LEFT and RIGHT OUTPUTS for stereo output. For BigSky, Mobius, NightSky, TimeLine, and Volante:  Connect a mono TS instrument cable into the LEFT INPUT and both LEFT and RIGHT OUTPUTS for stereo output.  On the TimeLine and Mobius ONLY, make sure that the switch on the back of the pedal is set to STEREO IN/OUT. Stereo Input => Stereo Output For Stereo input and Stereo output on our small 2 footswitch pedals (except blueSky and Ola), you must first open up the pedal to move the internal jumper over the LEFT 2 pins to set the pedal for TRS Stereo input.  Please see the following FAQ for further information on this setup: How to Set My 2 Button Strymon Pedal for Stereo Input Once the pedal is set for TRS Stereo input, make sure to use a TRS Stereo cable into the INPUT and connect a mono TS instrument cable to both the LEFT and RIGHT OUTPUTS of the pedal. For blueSky and Ola:  Connect a mono TS instrument cable into the LEFT and RIGHT INPUTS along with both LEFT and RIGHT OUTPUTS for stereo input and output.  The internal jumper on these pedals does not need to be adjusted to work in stereo and should be left in its default position (connecting the left 2 pins when viewed from below). For BigSky, Mobius, NightSky, TimeLine, and Volante:  Connect a mono TS instrument cable into the LEFT and RIGHT INPUTS along with both LEFT and RIGHT OUTPUTS for stereo input and output.  On the TimeLine and Mobius ONLY, make sure that the switch on the back of the pedal is set to STEREO IN/OUT.