Strymon Update support

[direct link]

Conduit

Remove any power connections to Conduit and connect the interface to your computer with the included USB-C cable via the USB-C jack.

Compadre, Riverside, and Sunset

These pedals have a micro-USB port located inside the chassis of the pedal that is accessible by removing the bottom plate.  Once the bottom plate is removed, the micro-USB port is found on the left side of the pedal.  You will need a micro-USB cable to connect your pedal to a USB port on a computer.

blueSky v2, Deco v2, DIG v2, El Capistan v2, Flint v2, and Lex v2

Connect the powered pedal to your computer with USB-C cable via the USB-C jack located on the back of the pedal.

Iridium, NightSky and Volante

Connect the powered pedal to your computer with the included USB-mini cable via the USB-mini jack located on the back of the pedal.

Magneto and StarLab Eurorack modules

Magneto has a USB-mini port located on the rear exposed circuit boards of the module.  Make sure to provide external power to Magneto while connecting the module to a computer using the included USB-mini cable to perform the update.

[direct link]

Using Strymon Update

With the Strymon Update software installed on your computer, run the application with your powered pedal or module connected to your computer via USB.  The Strymon Update software will automatically detect the connected device and show you the currently installed firmware version.

1. Click the ‘Check for Updates’ button for the software to check if there is an update available for your device.
2. If an update is available, click on the ‘Install Update’ button to perform the update.
3. Once completed, the ‘installed version’ will match the ‘latest available’ to show that your device is up to date.
4. Disconnect the device from your computer and power source.  Re-install the bottom cover if it was removed to update the pedal
5. Your device is now ready for use.

Check out the video below for additional help on performing the update: