How to adjust the Power Up modes on Volante

There are several Power Up Functions on Volante that control various global parameters.  All Power Up Function settings will persist through power cycles.

• To access the Power Up Functions:
  • Before powering up,  press and hold the TAP footswitch, then, plug in the power to the pedal.
  • After a few seconds, all the LED’s (except playback 4) will light up.  You can release the footswitch.

While in this state, the buttons and knobs correspond to the different Power Up Functions:

• Bypass mode
  • Press the feedback 1  button, status shown on button LED
    • True Bypass – GREEN (default)
    • Buffered Bypass – RED
• Persist – Repeats in the delay buffer will persist when the pedal is bypassed.
  • Press the feedback 2 button, status shown on button LED
    • Persist On – GREEN
    • Persist Off – RED (default)
• Output Sum – Sum the output signal to mono.  Use LEFT OUT for summed mono signal.
  • Press the feedback 3 button, status shown on button LED.
    • Stereo output – GREEN (default)
    • Sum output – RED
• Kill Dry – Mute the dry signal when Volante is both bypassed and engaged.
  • Press the feedback 4 button, status shown on button LED.
    • Kill Dry On – GREEN (dry signal is NOT present)
    • Kill Dry Off – RED (dry signal IS present, default)
• MIDI CC Out – Sends MIDI CC messages to the MIDI outputs when a corresponding knob, button, or switch is used on the pedal.
  • Press the playback 1 button, status shown on button LED.
    • Send MIDI CC On – GREEN
    • Send MIDI CC Off – RED (default)
• MIDI Program Change Out – Sends MIDI Program Change messages to the MIDI outputs when selecting a Favorite preset.
  • Press the playback 2 button, status shown on button LED.
    • Send MIDI Program Change On – GREEN
    • Send MIDI Program Change Off – RED
• DIN MIDI OUT mode – Determines what type of MIDI data is sent by the MIDI OUT port.
  • Press the playback 3 button – status shown on button LED
    • Out – GREEN (default), only messages generated by Volante’s controls are sent to the MIDI OUT port.
    • Through – RED, MIDI messages received at Volante’s MIDI IN are echoed to the MIDI OUT port without adding MIDI messages generated by the controls.

Factory Reset – Resets all presets, power up functions, and secondary parameters to factory settings.

• To access the Factory Reset:
  • Before powering up,  press and hold the ON footswitch, then, plug in the power to the pedal.
  • After a few seconds, the 8 playback (GREEN) and feedback (AMBER) LEDs will light up and the ON footswitch will be blinking RED.  You can release the footswitch.

While in this state:

• Sweep the TIME knob from 0% to 100% twice.
• Status shown on FAVORITE LED with it lighting up at the 0% (AMBER) and 100% (RED) extremes.
• When the reset is initiated, all 3 footswitch LEDs will be blinking RED.
• When the footswitches stop blinking, the pedal will power cycle and start up as normal.