How to I configure MultiSwitch Plus for CUSTOM mode?

To configure MultiSwitch Plus for CUSTOM* mode:

 

1- Connect one end of the included TRS cable to the EXP/MIDI (or EXP) jack of the pedal you wish to control. Power on the pedal.

2- Enter Custom Mode by holding down the C footswitch while connecting the TRS cable to any MultiSwitch Plus output. The C LED will flash RED to confirm the selection.

3- Release the footswitch. The LEDs on MultiSwitch Plus will flash GREEN to indicate configuration is complete.

*Not sure if your pedal supports MultiSwitch Plus’s CUSTOM mode? Check out the compatibility chart on page 4 of the manual here.